KANTECH KT 300 PDF
The Combus is a communication protocol that is integral to the KT It uses a four-conductor cable bus to which several expansion modules can be. Controls two doors and easily links to a network Update firmware directly from system workstation Fast operation, up to , baud Ready to go, no DIP. KANTECH SYSTEMS | KT/K Door Controller, 2-Reader, Kilobyte, ” Length x 3″ Width x ” Height, With Accessory Kit, Metal Cabinet with .
|Published (Last):||26 December 2017|
|PDF File Size:||10.14 Mb|
|ePub File Size:||9.39 Mb|
|Price:||Free* [*Free Regsitration Required]|
Does anyone have any ideas?
Kantech KT-300 Installation Manual
The ky that is seen says controller or module not assigned. I am having a similar problem with a kt being connected via USB.
I have a Kantech kt box. Kt Compliance Specifications Backup battery provides operation of up to 12 hours but has been tested only 4 hours per Section 33 kantecj UL, fifth edition. Built-in Combus expansion means that relay, input, and output modules can be added to connect HVAC systems, elevators, motion detectors, and more.
You need to be a member in order to leave a comment. Page 7 and installed correctly. Register a new account. Posted June 16, Comments to this Manuals Your Name. Installing The Kt The KT uses kajtech performance communication, proper grounding must be provided to ensure proper operation. Become a hattrix provider.
Don’t know if you resolved this but hopefully you figured to give Kantech a call. Share this post Link to post Share on other sites.
Their tech support is extremely helpful. Kantech KT Installation Manual 14 pages. The KT was communicating via the RS port and you installed a VC to communicate via the RS port; c You were using the KT at a local site and now want to configure it for remote operation.
Alarm Panel Integration Kits. Create an account or sign in to comment You need to be a member in order to leave a comment Create an account Sign up for a new account in our community.
In the event of a power surge or transient, a module may lock up and cease to communicate with the controller. There are liability issues relating to access control such as Fire code etc. After all wiring is completed, apply power to the KT Table of Contents Add to my manuals Add. Power outputs are supervised and individually protected against short-circuits and surges by self-resetting PTC.
Product offerings and specifications are subject to change without notice.
KANTECH KT INSTALLATION MANUAL Pdf Download.
Do not connect the power until all wiring is completed. By pressing ‘print’ button you will print only current page. Connect the external tamper switch, if used. I have set the baud rates to be the same on the port and in the software and I have the correct serial.
Page 4 Installation and Wiring Don’t have an account? Got it, continue to mantech.
Posted July 18, This module allows a maximum of 16 outputs and a maximum of up to 50 mA per output. Actual products ,t vary from photos. Overview Power outputs are supervised and individually protected against short-circuits and surges by self-resetting PTC.
I forgot to tell you that it was hooked up and unhooked before before i started with the company and I am just rehooking it back up. Posted June 6, The KT uses high performance communication, proper grounding must be provided to ensure proper operation.
The Combus is a communication protocol that is integral to the KT I tried the above steps but got no joy. Products which Kantech determines to be repairable will be repaired and returned.