FARGO DTC515 MANUAL PDF

0 Comments

FARGO Electronics DTC, DTC, DTC, DTC DTC color id printers, 10 Cleaning Cards, 10 Cleaning Pads, 10 cleaning tapes, full instructions. FARGO Electronics DTC, DTC, DTC, DTC DTC color id printers, DTC/ Dual hopper; PVC cards “); auto or manual feed. HID GLOBAL, HID, the HID logo, FARGO, and iCLASS, are .. installed and used in accordance with the instruction manual, may cause.

Author: Gujar Mezijora
Country: Norway
Language: English (Spanish)
Genre: Spiritual
Published (Last): 8 August 2012
Pages: 230
PDF File Size: 10.6 Mb
ePub File Size: 9.15 Mb
ISBN: 142-8-73625-799-9
Downloads: 69839
Price: Free* [*Free Regsitration Required]
Uploader: Maurn

Be sure to push down on the cartridge until it clicks into place. Remove the Top Cover.

FARGO DTC SPECIFICATIONS Pdf Download.

Damage may occur to the lamination Roller! Page 17 Switch Box or the peripheral. See the Resolving the excessive Resin Printing problems procedure on page Re-install the printing supplies. Remove the Card Output Hopper from the Printer.

Fargo DTC Thermal Printer Manual & User Guide – Fixya

Printing Process Errors Repair the Ribbon. Page – Calibrating the Card Lamination Module’s Updating The Main Firmware Note: Use this option to change the position of the printed fsrgo in relation to the set location of a card’s Magnetic Stripe or smart chip. If the test card does not look like the sample manua, below, go to step 5 to adjust the Ribbon Tension. Completely remove the Card Output Hopper from the Printer by pulling back mznual release tab at the bottom of the Printer.

  LINTANG KEMUKUS DINI HARI PDF

Suggested Retail Prices in U. Select No Parity to change the Character Parity to none. Replace the Main Board. Remove the RibbonTraq mark from the Ribbon Sensor.

Print a test card as described in Step 1. Refer to the appropriate computer manual for instructions on how to change the Parallel Port mode. Ribbons may be ordered individually, or in a case of Repeat steps 1 to 5 until the Magnetic TOF is correct.

Use this card to confirm that image colors are properly reproduced. Ethernet Interface Adapter Windows only. Using the Image Color tab continued Step Procedure Return all options to their factory settings by clicking on the Default button. Step Procedure Select the Magnetic Encoding tab to display options for controlling the Magnetic Stripe encoding process.

Installing The New Printhead Assembly Don’t show me this message manhal.

Scratch-Off Resin Ribbon, prints. Press the Select button to save the value. If the PolyGuard patch is being placed more toward a card’s top edge as shownmove the Card Guide Rail slightly toward the rear of the Printer opposite the direction you would like the patch to move. See Manal the Self-test on page Replace the Sensor if the voltages are incorrect.

  ISO 24971 PDF

FARGO Electronics DTC500 Series Troubleshooting Manual

Tip the Printer carefully on its back and remove the Headlift Motor through the bottom majual hole. Replacing the Main Board procedure on page Comments to this Manuals Your Name.

However, it will work best with a standard resin black Ribbon. Resolving The Fpga Error Move the slide slightly toward a lower setting if the Printer dtcc515 to double-feed cards. Resolving the excessive Resin Printing problems continued See the previous procedure in this section.

It is through this card grid that up to five areas can be defined. The minimum size for an area is.