AT89SJI Microchip Technology / Atmel 8-bit Microcontrollers – MCU 8K Flash 24M datasheet, inventory, & pricing. AT89S 8-bit Microcontroller With 8k Bytes Flash Features. Compatible with MCSTM Products 8K Bytes of In-System Reprogrammable Downloadable. This application note describes AT89S mem- ory sizes, features, and SFR mapping. More detailed information can be found in the. AT89S datasheet.

Author: Gugul Tehn
Country: China
Language: English (Spanish)
Genre: Marketing
Published (Last): 8 August 2005
Pages: 171
PDF File Size: 7.5 Mb
ePub File Size: 7.17 Mb
ISBN: 845-6-79128-452-8
Downloads: 15112
Price: Free* [*Free Regsitration Required]
Uploader: Moogular

The AT89S has a total of six interrupt vectors: Dataeheet set, causes the serial port to use Timer 2 overflow pulses for its receive clock in serial port. In fact, the service routine may have to determine.

AT89S8252 Datasheet PDF

MHz at dayasheet 16 MHz operating frequency. Timer 0 and Timer 1 in the AT89S operate the same. T0 timer 0 external input. Figure 2 shows Timer 2 automatically counting up when. Read accesses to these addresses will in general return.


To eliminate the possibility of. Data Pointer Register Select. Port 3 also serves the functions of various special features. Timer 0 and 1. The interconnection between master and slave CPUs with. Not implemented, reserved for future use.

AT89S Datasheet(PDF) – ATMEL Corporation

The baud rates in Modes 1 and 3 are determined by Timer. To access off-chip data memory with the MOVX. Timer 2 Mode Control Register.

Timer 2 is not being used to clock the serial port.

Atmel – datasheet pdf

External pullups are required during program. Neither of these flags is. The type of operation is. Program Store Enable is the read strobe to external pro.

Each of these interrupt sources can be individually enabled. Note that when idle mode is terminated by a hardware.

The prescaler bits, PS0, PS1. SCK Master clock output, slave clock input pin.

Timer 2 can be programmed to count up or down when. Port 1 pins that at98s8252 externally being pulled low will source. Interrupt Enable IE Register. Timer 2 has three operating modes: Modes 1 and 3. In addition, the transition at T2EX. When all three bits are set to “1”, the nominal period is ms. Timer function, the TL2 register is incremented every.


When the WDT times out without. Timer or counter select for Timer 2. Port 0 can also be configured to be the multiplexed low. A map of the on-chip memory area called the Special Func. In th e ca pture modetwo op tions a89s8252 selected b y b it.

Timer 2 Operating Modes. Interrupt Recovery From Power-down. The SPDR is double buff.

Atmel AT89S8252

The baud rate generator mode is similar to the auto-reload. Under these conditions, the Timer is. When 1s are written to Port 2 pins, they are pulled high by. Timer 0 interrupt aat89s8252 bit.