CD4018B DATASHEET PDF
DESCRIPTION. The HCFB is a monolithic integrated circuit fabricated in Metal Oxide Semiconductor technology available in DIP and SOP packages. Data sheet acquired from Harris Semiconductor. SCHSC − Revised October The CDB types are supplied in lead hermetic dual-in-line. CDB datasheet, CDB pdf, CDB data sheet, datasheet, data sheet, pdf, Texas Instruments, CMOS Presettable Divide-By-N Counter.
|Published (Last):||18 September 2006|
|PDF File Size:||4.77 Mb|
|ePub File Size:||19.1 Mb|
|Price:||Free* [*Free Regsitration Required]|
You can buy binary encoded switches The carry out is always 1 clock pulse wide.
Second problem was that, probably because of the low voltage of the littlebits power supply, the AND gate output wasn’t pushing enough current to drive the data in on the Basically it’s a straight datasheet functionality of a cd divide by n counter. You can use the DIP switch and diodes to provide the same sort of dxtasheet selector, or just stick with binary input.
Regarding the transistor though, whether it should be able to or not, the is capable of driving both an output led and triggering a littlebits microsquencer straight from the data pin, as long as it’s doing an even division.
If I end up making more cd4018h these, do you know if there’s a equivalent for the ?
The data pin on the will work fine from the common of the dip switch. First problem was that the data sheet says to tie the outputs vd4018b with a NAND gate Would appreciate any feedback before I commit it to perf board and build a second one. This was fixed by the addition of a -very- mickey mouse transistor amp stage. I made it mostly for driving microsequencers at “triplet” rates.
I would use a 74LS which is a synchronous counter that can be programmed. A selector switch would’ve been a lot better than a dip switch, but it was readily available.
Thanks for the response. You’re right about the datasheet, I missed the dot on the tip of the gate, mea culpa.
A 74LS08 has more output drive with a slightly different dc4018b out. Your arduino midi interface is actually next on the build list.
Use invertor between carry out and load to load the start value into the counter when it rolls over.
Everything is also made a bit more difficult by the output being part of the feedback that determines the division rate. I spent the last two evenings putting this together on a breadboard.
CDB Datasheet pdf – CMOS Presettable Divide-By-N Counter – Texas Instruments
The hard part comes in that if you want to divide by odd numbers, you need to throw in some external logic. The datasheet uses Nand followed by invertor to get the AND functionality. If anyone cares to give it a good proof reading, again, it would be appreciated. You could add isolating diodes so that you do not have that worry. If you want to be more flexible, a simple atmega P chip can be used and programmed to provide any pattern you want to output.
Sorry for the schematic, I drew it up in MSPaint and it has been a while since I’ve drawn a schematic. The is a twisted ring counter, there are several ttl programmable counters. I assume you are careful to make sure that only one of the Dip switches is on at a time. I would be particularly interested in knowing what the proper value of the resistor between the emitter and ground should be.
I could not, however, run the output of a to the data pin with any success unless I first amplified it.
Trigger pulse goes in and, depending on how it’s set, for every x pulses in you get 1 pulse out.